Optimum OPTImill F 80 Betriebsanleitung Seite 369

Brief instruction 808D Milling
SEQUENCE
User
Program
interface
example
This describes and analyzes the additive offset, coordinate rotation, scaling functions
mentioned above.
Machining target dimension drawing and the final effect are as follows:
In this example, the positive
direction of the XY coordinate
axis is different when machining
each groove!
808D
Additional Information Part 2
Drawing 1 — original workpiece
machining
Drawing 2 — coordinate rotates 100º
Drawing 3 — ① Drawing 2 along X axis
mirror image
② Coordinate rotates 20º
Drawing 4 — ① Drawing 3 along Y axis
moves 60 in negative direction
② enlarge 1.3 times in X and Y
direction
N10
SUPA G00 Z300 D0
N15
SUPA G00 X0 Y0
N20
G17 T1 D1
N25
MSG ("change to 1 tool")
N30
M5 M9 M00
N35
S5000 M3 G94 F300
N40
G00 X-28 Y 30
N45
G00 Z2
N50
LAB1:
N65
POCKET3( 50, 0, 2, -5, 30, 15, 3,
-28, 30, 0, 5, 0, 0, 300, 100, 0, 11, 5,
, , 5, 3, )
N70
LAB2:
N75
M01
N80
ROT RPL=-100
N85
REPEAT LAB1 LAB2 P1
N90
M01
N95
AMIRROR X=1
N100
AROT RPL=-20
N105
M01
N110
REPEAT LAB1 LAB2 P1
N115
AROT RPL=10
N120
ATRANS Y-60
N125
AROT RPL=-10
N130
ASCALE X1.3 Y1.3
N135
REPEAT LAB1 LAB2 P1
N140
M30
Page 369
OPTIMUM
M A S C H I N E N - G E R M A N Y
N10
SUPA→cancel all settable offsets
N15
N20
coordinate plane G17,use tool 1
N25
N30
N35
N40
N45
N50
LAB1:milling start sign
N65
milling rectangular groove(depth 5 mm,
length 30 mm, width 15 mm, corner radius 3 mm, groove
datum coordinate (X-28,Y30), groove longitudinal axis and
plane X axis clamping angle 0º)
N70
LAB2:milling groove end sign
N75
N80
coordinate axis rotates 100º in positive direction
N85
machining the same groove at the new position
N90
N95
along the new X axis to change the mirror image
N100
coordinate axis rotates -20º in positive direction
N105
N110
machining the same groove at the new position
N115
coordinate axis rotates –10º in negative direction
N120
Y axis coordinate moves 60 in negative direction
N125
N130
groove enlarged 1.3 times in the X,Y direction.
N135
machining the same groove at the new position
N140
end
Operating and Programming — Milling