Optimum OPTImill F 80 Betriebsanleitung Seite 345

Brief instruction 808D Milling
SEQUENCE
Step 2
Press the "Simu." SK on the PPU.
If this message is displayed at the bottom of the screen,
press the "AUTO" mode key on the MCP.
808D
Simulate Program
Step 3
If the control is not in the
correct mode, a message
will be displayed at the
bottom of the screen.
Press the "Edit" SK on the PPU to return to the program.
End
Page 345
Press the "CYCLE START" key on the MCP.
Operating and Programming — Milling
OPTIMUM
M A S C H I N E N - G E R M A N Y
If the control is not in the
correct mode, a message
will be displayed at the
bottom of the screen.