Avoiding Misuses - Optimum OPTImill F 80 Betriebsanleitung

OPTIMUM
M A S C H I N E N - G E R M A N Y
1.5.1

Avoiding misuses


Use of suitable cutting tools.

Adapting the speed adjustment and feed to the material and workpiece.

Clamp workpieces firmly and vibration-free.
ATTENTION!
The workpiece is always to be fixed by a machine vice, jaw chuck or by another
appropriate clamping tool such as for the clamping claws.
WARNING!
Risk of injury caused by workpieces flying off.
Clamp the workpiece in the machine vice. Make sure that the workpiece is firmly clamped in the
machine vice resp. that the machine vice is firmly clamped on the machine table.

Use cooling and lubricating agents to increase the durability of the tool and to improve the
surface quality.

Clamp the cutting tools and workpieces on clean clamping surfaces.

Sufficiently lubricate the machine.

Correctly adjust the bearing clearance and the guidings.
ATTENTION!
Do not use the drill chuck for milling tools. Never clamp a milling cutter into a drill
chuck. Use a collet chuck with collets for the end mill.
1.6 Possible dangers caused by the CNC-machine
The CNC-machine was tested for operational safety. It has been designed and built using the
latest technological advances.
Nevertheless, there is a residual risk as the CNC-machine operates with
rotating parts,

electrical voltage and currents,

compressed air,

rapid moves.

We have used construction resources and safety techniques to minimize the health risk for the
staff resulting from these hazards.
If the CNC-machine is used and maintained by the staff who are not duly qualified, there may
be a risk resulting from incorrect or unsuitable maintenance of the CNC-machine.
INFORMATION
All staff involved in assembly, commissioning, operation and maintenance, must
be duly qualified,

strictly follow these operating instructions.

During improper use
there may be a risk to the staff,

there may be a risk to the CNC-machine and other material values,

the correct function of the CNC-machine may be affected.

Always switch off the CNC-machine and disconnect it from the mains if you perform cleaning or
maintenance works.
GB F80 | F105
Page 212
®
Translation of the original instructions
Safety
Version 1.1.2 dated 2019-05-07