Optimum OPTImill F 80 Betriebsanleitung Seite 286

OPTIMUM
M A S C H I N E N - G E R M A N Y
700034 Block search, tool in spindle <> programmed tool
700035
700036
700037 Do not move MGZ when Z axis under the tool change pos.
700038
700039 Turn magazine when alarm or tool not retracted
700040 Start ATC when Z axis not in tool change pos.
700041
700042
700043
700044
700045
700046
700047
700048
700049
700050
700051
700052
700053
700054
700055
700056 Change of spindle direction not possible in thread
700057
700058
700059
700060 Channel not in reset, change PRT not possible
700061
700062
700063
700064
700065
700066
700067
700068
GB 808D
Page 286
®
Spindle not reach tool-release pos. in time
Spindle not reach tool-lock pos. in time
User alarm 39
Move Z axis when ATC not in original position
ATC not finish action in monitor time
Change tool when magazine not in run mode
Magazine motor overload
ATC motor overload
User alarm 47
User alarm 48
User alarm 49
Reference point x-axis not reached
Reference point z-axis not reached
Wrong spindle direction started
Watchdog timer JOG-program
Spindle override not 100%
Spindle is not started
Feed override =0%
User alarm 58
User alarm 59
safety door not closed, NC start not possible
User alarm 62
User alarm 63
User alarm 64
User alarm 65
User alarm 66
User alarm 67
User alarm 68
User alarm 69
Original operating instructions
Notes, messages and error messages
Version 1.1.2 dated 2019-05-07