Intended Use - Optimum OPTImill MH 25 SV Betriebsanleitung

Warning: automatic start-
up!
Activation forbidden!
Wear protective gloves!
Only switch when stopped!
1.3

Intended use

WARNING!
In the event of improper use, the milling machine

will endanger personnel,

the milling machine and other material property of the operating company will be
endangered,

the correct function of the milling machine may be affected.
The milling machine is designed and manufactured to be used for milling and drilling cold met-
als or other non-flammable materials or materials that do not constitute a health hazard by
using commercial milling and drilling tools.
The milling machine must only be installed and operated in a dry and well-ventilated place.
If the milling machine is used in any way other than described above, modified without the
approval of the company Optimum Maschinen Germany GmbH, the milling machine is being
used improperly.
We will not be held liable for any damages resulting from any operation which is not in accord-
ance with the intended use.
We expressly point out that the guarantee or CE conformity will expire, if any constructive, tech-
nical or procedural changes are not performed by the company Optimum Maschinen Germany
GmbH. It is also part of intended use that you
the maximum values for the milling machine are complied with,

the operating manual is observed,

the inspection and maintenance instructions are observed.


"Technical data" on page 65
Version 1.0.1 dated 2015-12-17
Warning: tilting danger!
Read the operating instruc-
tions before commission-
ing!
Wear safety shoes!
Protect the environment!
Original operating instructions
OPTIMUM
M A S C H I N E N - G E R M A N Y
Warning: suspended loads!
Disconnect the mains plug!
Wear a protective suit!
Contact address
Caution, danger of explo-
sive substances!
Wear protective glasses!
Use ear protection!
MH25SV GB
Page 55