Optimum OPTImill F 80 Betriebsanleitung Seite 270

OPTIMUM
M A S C H I N E N - G E R M A N Y
6.5.4 Inserting a tool
INFORMATION
Before you can run a CNC program, at least one tool must have been created and
measured in the tool memory.

Change over to the mode <JOG>.

Press the "Offset" key on the
machine control panel.

Press the "Tool list" softkey

For the following working steps,
please proceed as described in
„Operation and programming" of
the Siemens SINUMERIK 808D
Operation instructions.
6.5.5 Clamping workpiece and setting workpiece datum
ATTENTION!
The workpiece is always to be fixed by a machine vice, jaw chuck or by another
appropriate clamping tool such as for the clamping claws.
When setting and using already created programs observe the safety clearance in order
to avoid collisions with the selected clamping means.
WARNING!
Risk of injury caused by workpieces flying off.

Clamp the workpiece in the machine
vice.

Make sure that the workpiece is firmly
clamped in the vise.
6.5.6 Manual tool change
ATTENTION!
Hold your tool if there is a tool inserted in the spindle.

Press the push button "Open/Close door" and open the sliding door.

Check that the LED on the pushbutton <K11>lights up.
Press - if necessary - the pushbutton <K11>. The manual tool change
is thereby enabled again.
GB F80 | F105
Page 270
®
Workpiece
Machine vice
Translation of the original instructions
Img.6-3: Clamping the workpiece
Version 1.1.2 dated 2019-05-07
K11
Operation