Control And Indicating Elements - Optimum OPTImill F 80 Betriebsanleitung

OPTIMUM
M A S C H I N E N - G E R M A N Y
6 Operation
6.1 Safety
Commission the CNC-machine only under the following conditions:
The CNC-machine is in proper working order.

The CNC-machine is used as intended.

The operating manual is followed.

All safety devices are installed and activated.

All failures should be eliminated immediately. Stop the CNC-machine immediately in the event
of any failure in operation and make sure that it cannot be started-up accidentally or without
authorization. Notify the person responsible immediately of any modification.

"Safety during operation" on page 218
6.2

Control and indicating elements

Img.6-1: F80
No.
1 Touch-switch to release and clamp the tool.
2 Milling spindle
3 Tool change system incl. magazine disk
7 Milling table
8 Signal lamp (if the signal lamp is illuminated --> CNC- program is running)
9 Machine Control Panel
10 Emergency-stop push button
Handwheel for manual travelling with emergency stop push button and acknowl-
11
edgement button
GB F80 | F105
Page 264
®
10
3
7
Designation
Translation of the original instructions
1
8
9
10
11
Version 1.1.2 dated 2019-05-07
2
Operation