Optimum OPTImill F 80 Betriebsanleitung Seite 339

Brief instruction 808D Milling
Basic Theory
After opening the contour data setting window, please make the following settings:
After completing the steps, the system will return to the
edit interface. Press "Technical interface" on the PPU to
return to the interface for setting the cycle data.
After finishing the parameter settings of CYCLE72,
press the "OK" SK on the PPU to insert the
corresponding cycles in the main program.
808D
Create Part Program Part 2
Enter appropriate
coordinates based on the
data from the technical
drawing.
After all the settings take effect, the selected cycle and set data will be transferred to
corresponding part program automatically
(for further information, see next page).
Page 339
OPTIMUM
M A S C H I N E N - G E R M A N Y
Operating and Programming — Milling