Optimum OPTImill F 80 Betriebsanleitung Seite 354

Brief instruction 808D Milling
SEQUENCE
Transfer a part program to a PC from the PPU.
Step 2
Press the "NC" SK on the PPU.
Use "Cursor + Select" to select the required part program. The
selected program will be highlighted.
Press the "Copy" SK on the PPU.
Press the "RS232" SK on the PPU.
Check the interface setting and start the communication software to receive the
program on PC.
(Press "Receive Data" on SINUCOM PCIN to start the receive function.)
Press the "Send" SK on the PPU.
The PPU will display a window showing the progress of the transfer.
If there is a problem during transfer of the part program, a window will be displayed.
808D
Additional Information Part 1
You can continue sending the part program.
Or you can abort the sending of the part program.
Or
Step 3
Check the interface setting and start the communication software to send the program
from PC.
(Press "Send Data" on SINUCOM PCIN to send data.)
The PPU will display a window showing the progress of the transfer.
Page 354
Press the "OK" SK on the PPU.
Press the "Cancel" SK on the PPU.
Transfer a part program to the PPU from a PC.
Press "Program Manager" on the PPU.
Press the "RS232" SK on the PPU.
Press the "Accept" SK on the PPU.
Operating and Programming — Milling
OPTIMUM
M A S C H I N E N - G E R M A N Y