Optimum OPTImill F 80 Betriebsanleitung Seite 352

Brief instruction 808D Milling
SEQUENCE
The feedrate override must always be set to 0%!
Make sure the correct tool is selected before continuing!
Press the "CYCLE START" key on the MCP to execute
Alarm 010208 is shown at the top prompting to press the "CYCLE START" key to
continue the program.
808D
Program Restart
the program.
Press the "CYCLE START" key on the MCP to execute
Turn the feedrate override on the MCP gradually to the required value.
Page 352
OPTIMUM
M A S C H I N E N - G E R M A N Y
the program.
Operating and Programming — Milling