Optimum OPTImill F 80 Betriebsanleitung Seite 309

Brief instruction 808D Milling
SEQUENCE
MCP mode
Reference
Changing
the
machine
Step 1
Step 2
808D
Switch On and Referencing
If your machine is configure with ABS encoder, you
do not need to reference the axis of the machine.
If your machine is fitted with INC encoder, After
power on, the machine must first be referenced!
After power on, the machine will be in the
reference point approach mode (default).
If the axis is not referenced, the non-
referenced symbol (circle) is displayed
between the axis identifier and the value.
The axes are referenced with the
corresponding axis traversing keys.
The traversing direction and keys are
specified by the machine manufacturer.
Step 3
End
Page 309
OPTIMUM
M A S C H I N E N - G E R M A N Y
After completing the referencing procedure for
all axes, the referenced symbol is displayed
next to the axis identifier.
After returning to JOG mode, use the axis
traversing keys to move the machine manually.
The machine can now be operated in JOG
mode.
During normal operation (JOG),the referenced
symbol is not shown on the screen.
Operating and Programming — Milling