Optimum OPTImill F 80 Betriebsanleitung Seite 368

Brief instruction 808D Milling
SEQUENCE
User
Coordinate
rotation
interface
ROT AROT
The programmable rotation ROT, AROT can be used:
The rotation is performed in the current plane G17, G18 or G19 using the value of
RPL=...specified in degrees.
ROT RPL=... ; programmable rotation offset (absolute).
AROT RPL=... ; programmable offset, additive to existing offset (incremental)
ROT ; without values, clears old commands for offset
N10 G17
N20 AROT RPL=45 additive 45 degree rotation
L10 subprogram call
808D
Additional Information Part 2
Machine
coordinate
A scale factor can be programmed for all axes with SCALE, ASCALE. The path is
enlarged or reduced by this factor in the specified axis. The currently set coordinate
system is used as the reference for the scale change.
SCALE X...Y... Z...
ASCALE X...Y... Z... ; programmable offset, additive to existing offset
If a program contains SCALE or ASCALE, this must be programmed in a separate block.
Programming example
N10 G17
N20 SCALE X2.0 Y2.0
L10
Page 368
Scaling
system
; programmable rotation offset (absolute)
(incremental)
; contour is enlarged two times in X and Y
subprogram call
Y
Workpiece
36
ATRNS X....Y....
SCALE X2 Y2
W
Original
5
Operating and Programming — Milling
OPTIMUM
M A S C H I N E N - G E R M A N Y
N60
N40
X
Workpiece