Optimum OPTImill F 80 Betriebsanleitung Seite 338

Brief instruction 808D Milling
Basic Theory
Contour milling
with cycle
The easiest way to rough
and finish around a
contour is to use the
contour milling function.
The cycle can be found
and parameterized via the
"Mill." SK.
Edit
The "Contour milling" SK
can be found in the
vertical SKs on the right.
Contour
milling
The parameterization is
performed as in this
figure.
808D
Create Part Program Part 2
Cont.
Drill. Mill. Active
Name of contour subroutine
By selecting the "New file" SK, the contour turning data can be inserted into
New
file
Sub Program File (.SPF). You can edit and change it when selected. The
sequence is as follows:
Execute
Renumber
Search
Mark
On
Copy
Paste
Re-
Simu.
comp.
New
file
Attach
contour
Cancel
OK
Edit Cont.
Page 338
OPTIMUM
M A S C H I N E N - G E R M A N Y
Enter the cycle data setting
according to the former operations in
the screen and enter the name of the
Name of contour subroutine
New
contour subprogram.
file
Attach
contour
Press "New file " on the PPU to
create contour information in the
.SPF file. The cursor moves to the
Cancel
contour editing position
OK
automatically.
Make sure that the cursor has
moved to the contour writing
position (as shown in the
figure).
Search
Mark
On
Copy
Paste
Tech
interface
Operating and Programming — Milling
Contour
milling
New
file