Optimum OPTImill F 80 Betriebsanleitung Seite 357

Brief instruction 808D Milling
On PC create a shared folder.
Step 3
Anywhere on your PC create a new folder with a simple name (do not use special
characters). This example creates a folder named "Test". Once created, right-click the
folder and select "Properties." then select the pull down menu "Sharing".
In the dialog window, select "Advanced Sharing"
Then check "Share this folder"
Then select "Permissions" and check "Full control"
Select "OK" - "Ok" - "Close" to activate the settings.
In this folder you can put some machining program.
Add the network drive on the PPU side to activate the shared folder, and
Step 4
online processing
In the "Network drive configuration" screen select "Net drv. Config."
808D
Additional Information Part 1
SEQUENCE
In the "Network Drive
Configuration" Enter PC
login user name,
password, and path of
where shared folder is. In
accordance to the format
required.
Server: IP address
Share Name: the name of
the shared folder
Note: Use "TAB" key to
switching between
different tasks boxes.
After set successful, the
screen will displayed
"Network drive added
successfully" while the set
path is automatically written
to the "drive" Window.
Page 357
If your PC does not set user name
and password
You do not need to enter
Press "Add Drive" SK to add it to the specified drive letter
Operating and Programming — Milling
OPTIMUM
M A S C H I N E N - G E R M A N Y