Optimum OPTImill F 80 Betriebsanleitung Seite 315

Brief instruction 808D Milling
SEQUENCE
Press the axis keys on the MCP to move
the tool to the set position above the
workpiece.
Note: The following text describes the required
settings in the workpiece coordinate system
"X / Y / Z" zero points as:"X0" / "Y0" / "Z0"
Press the "Handwheel" key on the MPC
and position the tool at location Z0 or
the workpiece.
Move directly to zero point
808D
a of
or
a
Use a setting block.
Tool Setup
Use "SELECT" key to set the reference point as
"workpiece" (In real measurement, the reference
point can be set as either "workpiece" or " fixed
(If the setting block is used, then the value would
Tool measurement maual
Set
Meas.
REL work.
Press the "Set length" SK on the PPU
The measured tool length is now shown in "Length (L)". This value is also saved in the
length value column of the corresponding tool list at the same time.
Step 2
Measure diameter
Press the "Diameter" SK on the PPU
Page 315
OPTIMUM
M A S C H I N E N - G E R M A N Y
point" if required.)
Enter "0" for "Z0"
be thickness a)
Use workpiece
Ref. point Workpiece
Length (L)
Meas. Face
tool
cutt.
Operating and Programming — Milling
Set
length
Back
Sett.
Set
length
Diameter