Optimum OPTImill F 80 Betriebsanleitung Seite 375

Brief instruction 808D Milling
Machining Process
N290 G0 X0 Y0
; =============Start circular pocket
roughing==============
N300 POCKET4( 50, 0, 2, -5, 7.5, 0, 0, 2.5, 0.1,
0.1, 300, 200, 0, 21, 2, , , 4, 1)
N310 S4500 M3
; =============Start circular pocket
finishing==============
N320 POCKET4( 50, 0, 2, -5, 7.5 , 0, 0, 5, 0.1,
0.1, 300, 200, 0, 12, 2, , , 4, 1)
N330 G0 Z100
; =========Start drilling==========
N340 T3 D1 ;DRILL D3
N350 M6
N360 S5000 M3
N370 G0 X0 Y0
N380 MCALL CYCLE81( 50, 0, 2, -5, 0)
N390 HOLES2( 0, 0, 10, 45, 60, 6)
N400 MCALL
N410 M30
808D
Sample Program
N290 back to workpiece zero point
; =====Start circular pocket roughing=====
N300 milling circular groove (depth 5 mm, radius
7.5 mm, groove base point coordinate (X0,Y0),
angle between groove vertical axis and plane X
axis is 0º), milling direction is positive, rough
machining.
N310
; =====Start circular pocket finishing=====
N320 milling circular groove (depth 5 mm, radius
7.5 mm, groove basic point coordinate(X0,Y0), the
clamping angle between the groove vertical axis
and plane X axis is 0), finish machining allowance
0.1 mm, milling direction is positive, finish
machining, use G1 vertical groove center to insert.
N330 G0 Z100
; =========Start drilling==========
N340 3 tool is drilling tool diameter 3 mm
N350
N360
N370 back to workpiece zero point
N380 drilling depth 5 mm, use "MCALL" mode to
use command, means drilling position decided by
the parameters in N490
N390 circular line hole forms cycle
command(circular center point coordinate(X0,Y0),
radius 10 mm, angle between the line with first hole
and circular center point and the X axis in positive
direction is 45º, angle between the holes is 60º,
circular hole number 6 →)
N400 cancel mode use
N410 M30
Drawing
Milling
program 2
Tool information:
T1 Milling tool D50
T2 Milling tool D12
T4 Milling tool D10
Page 375
OPTIMUM
M A S C H I N E N - G E R M A N Y
Make sure all the preparations and safety measures
have been performed before machining!
Workpiece zero point
is located in the top
left corner.
Operating and Programming — Milling