Optimum OPTImill F 80 Betriebsanleitung Seite 260

OPTIMUM
M A S C H I N E N - G E R M A N Y
Excerpt from the manual of the operating instructions for "SINUMERIK 808D OPM Operation"
Axis traversing keys
7
GB F80 | F105
Page 260
®
Element
Reverse rotation of the chip conveyor
(active only in JOG mode)
Keeping pressing this key in any operating mode rotates the chip
conveyor in reverse order.
Releasing the key changes the chip conveyor to the previous
forward rotation or stop state.
LED on: The chip conveyor starts reverse rotation.
LED off: The chip conveyor stops reverse rotation.
fore, the key has no function.
User-defined keys
Position of tool changer
The <K9> key lights up when the tool changer is extended.
K9
In the reference mode, the key can be pressed to move the tool
changer out. The milling spindle must be located above the tool
changer.
Position of tool changer
The <K10> key lights up when the tool changer is in the basic
K10
position.
In the reference mode, the key can be pressed to move the tool
changer to the basic position. The milling spindle must be located
above the tool changer.
Manual tool change
K11
Enables or disables the manual tool change.
The manual tool change is only possible with the sliding door open.
X axis key
Traverses the X axis in the positive direction.
X axis key
Traverses the X axis in the negative direction.
Z axis key
Traverses the Z axis in the negative direction.
Translation of the original instructions
Description
INFORMATION
The F80 | F105 does not have a chip conveyor. There-
User interface, machine control panel
Version 1.1.2 dated 2019-05-07