Optimum OPTImill F 80 Betriebsanleitung Seite 316

Brief instruction 808D Milling
SEQUENCE
Press the axis keys on the MCP to move
the tool to the set position.
Press the "Handwheel" key on the MCP
and position the tool at the location
X0 or a of the workpiece.
Move directly to zero point
808D
a
or
Use a setting block.
Tool Setup
(This is the value of the width of a setting block if it
is used.Select one of X0/Y0 according to
Tool measurement manual
Set Meas.
rel work.
Press the "Set diameter" SK on the PPU
Press the "Back" SK on the PPU
Page 316
OPTIMUM
M A S C H I N E N - G E R M A N Y
Enter "0" at "X0"
Enter "0" at "Y0"
requirement.)
Workpiece edge
Diameter
Meas.
Face
cutt.
tool
Operating and Programming — Milling
Set
diameter
Back
Sett.
Set
diameter
back