Operating Material - Optimum OPTImill F 80 Betriebsanleitung

OPTIMUM
M A S C H I N E N - G E R M A N Y
11 Maintenance
In this chapter you will find important information about
Inspection

Maintenance

Repair

of the CNC-machine.
ATTENTION!
Properly performed regular maintenance is an essential prerequisite for
operational safety,

failure-free operation,

long service life of the CNC-machine and

the quality of the products which you manufacture.

Installations and equipment from other manufacturers must also be in good order and condition.
ENVIRONMENTAL PROTECTION
During work on the cooling lubricant equipment please make sure that
collector tanks are used with sufficient capacity for the amount of liquid to be col-

lected.
liquids and oils should not be split on the ground.

Clean up any spilt liquid or oils immediately using proper oil-absorption methods and dispose of
them in accordance with current legal requirements on the environment.
Collect leakages
Do not re-introduce liquids split outside the system during repair or as a result of leakage from
the reserve tank:collect them in a collecting container to be disposed of.
Disposal
Never dump oil or other substances which are harmful for the environment in water inlets, rivers
or channels. Used oils must be delivered to a collection centre. Consult your supervisor if you
do not know where the collection centre is.
11.1

Operating material

11.1.1 Machine lubricants
Only use appropriate lubricants which guarantee a safe operation of the machine.
Recommended lubricant class: ISO V668
Recommended lubricant: guideway oil Mobil Vactra (Oil No. 2) 2)
11.1.2 Cooling lubricants
In order to avoid interferences during operation the water-mixed cooling lubricant and the slide-
way oil or grease need to be compatible.
INFORMATION
The CNC-milling machine is lacquered with a one-component paint. Observe this fact when
selecting your cooling lubricant.
The company Optimum Maschinen Germany GmbH does not assume any guarantee on subse-
quent damages due to unsuitable cooling lubricants.
The flashing point of the emulsion must be higher than 140°C.
GB F80 | F105
Page 290
®
Translation of the original instructions
Maintenance
Version 1.1.2 dated 2019-05-07