Optimum OPTImill F 80 Betriebsanleitung Seite 341

Brief instruction 808D Milling
Basic Theory
Milling slots
and spigots
The easiest way to mill a
slot is to use the SLOT2
cycle.
The cycle can be found
and parameterized via the
"Mill." SK.
The relevant cycle can
be found using the
vertical SKs on the right.
Circumf.
Slots
→
slots
Select "slot" using the
vertical SKs and
parameterize the cycle
according to requirement.
808D
Create Part Program Part 2
With the "OK" SK, the values and cycle call will be
transferred to the part program as shown below.
This will perform milling at the position defined in the cycle.
actual effect
Page 341
OPTIMUM
M A S C H I N E N - G E R M A N Y
Operating and Programming — Milling