Optimum OPTImill F 80 Betriebsanleitung Seite 302

OPTIMUM
M A S C H I N E N - G E R M A N Y
The adjustment of the dog position is performed at the position of the oil inlet. Therefore turn
the table in jog mode to the oil inlet. At this position, the adjustment can be easily done.
Oil inlet
Loosen the screws (G) on the dog. Move the dog in the correct position. The dog has circumfer-
ential slots for a shift of about ± 7.5mm.
Oil inlet
Annotation: When loosen two screws, please do not loosen completely in order to prevent them
from dropping into the interior of machine.
GB CNC 120-R
Page 302
®
Dog
Screw (G)
Dog
Screw (G)
Translation of the original instructions
Sensor
Screw (G)
Sensor
Screw (G)
Version 1.1.2 vom 2019-05-07