Optimum OPTImill F 80 Betriebsanleitung Seite 346

Brief instruction 808D Milling
Test Program
Description
This unit describes how to simulate a part program before executing it in AUTO mode.
Content
Program
Execution
Dry Run
End
808D
Test Program
Basic Theory
Program
Execution
Press the "Execute" SK on the PPU.
The control is now in AUTO mode with the
current opened program storage path being
displayed and the AUTO lamp on the MCP is
Now the program is ready to start and the actual
operation will be described in the next section!
Page 346
OPTIMUM
M A S C H I N E N - G E R M A N Y
Before the part program can be loaded and executed
in AUTO mode, it must be tested using the simulation
function mentioned previously!
on.
Operating and Programming — Milling