Optimum OPTImill F 80 Betriebsanleitung Seite 388

Brief instruction 808D Milling
Basic Theory
Beginning of the program
Common ISO program
Common ISO program:
O0001;
Beginning is "O"
G0 X50 Y50 Z50 M5
ISO mode of 808D:
Not compatible with the programs
G04 X5
beginning with "O"
M3 S1000
...
Note: Every tool only can use the H value corresponding to the edge.
In the graphic above, T2 H1 cannot be executed.
808D
ISO Mode
808D ISO program
O0001;Delete this line
G0 X50 Y50 Z50 M5
G04 X5
M3 S1000
...
H code
In 808D standard DIN mode, you must
open the H list in the tool list first and
fill in the data accordingly
2 common methods
①
Direct use of the ISO switch button
on the PPU to enter ISO mode.
(We recommend the 1st method!)
②
Enter code G291 in MDA mode
and execute. When the "Reset" is not
used, the H list in the tool list is open.
Page 388
Program execution
Step 3
Make sure the current system is in ISO mode!
Make sure all preparations and safety measures have been performed!
Operate as described above.
Tool and workpiece setup simulation
→
Transfer the ISO files in the 808D to the USB device.
Step 4
Connect the USB device with sufficient memory to the USB interface on the PPU.
Press the "NC" SK on the PPU.
Use the "Cursor + Select" keys to select the required
program which is then highlighted.
Press the "Copy" SK on the PPU.
Press the "USB" SK on the PPU.
Press the "Paste" SK on the PPU.
A specified ISO program is then stored in the USB and can be executed as required.
Operating and Programming — Milling
OPTIMUM
M A S C H I N E N - G E R M A N Y
test machining.
→ →
+