Optimum OPTImill F 80 Betriebsanleitung Seite 344

Brief instruction 808D Milling
Simulate Program
Description
This unit describes how to simulate a part program before executing it in AUTO mode.
Content
Simulate
program (Axis
do not move)
End
808D
Simulate Program
Basic Theory
Simulate
program (Axis
do not move)
Step 1
The part program must be opened using the "Program Manager" on PPU.
Page 344
OPTIMUM
M A S C H I N E N - G E R M A N Y
A part program must have been created before
it can be tested using "Simulation".
Operating and Programming — Milling