Optimum OPTImill F 80 Betriebsanleitung Seite 395

13.5 Terminology/Glossary
Term
Cross table, milling table
CAD
CAM
CAP
CNC
NC
ATC
MCP
PPU
Workpiece
Spindle head
Spindle sleeve
Milling spindle
Tool
Machine Control Panel
Separating protective equip-
ment
Step motor
Servo motor
Annex
Version 1.1.2 dated 2019-05-07
Explanation
Bearing surface, clamping surface for the workpiece with X- and Y-axis travel
C omputer A ided D esign
C omputer A ided M anufacturing
C omputer A ided P lanning
C omputerised N umerical C ontrol
N umericial C ontrol
A utomatic T ool C hanger
M achine C ontrol P anel
P oly P ower U nit
Piece to be milled, drilled or machined.
Milling head, upper part of the CNC-milling machine
Hollow shaft in which the milling spindle turns.
Shaft activated by the motor
Milling cutter, drill bit, etc.
Control panel, keyboard and screen of the CNC machine
Cover, housing
Synchronous motor where the rotor (turnable piece of the motor with a shaft) can be
turned targeted around an angle if the triggered stator coils (non-turnable piece of the
motor) is well selected.
A motor which can travel to different predetermined positions and will maintain there.
In this case, the position is an angular position of a rotatory motor and in case of a
linear motor it is a linear positioning. The starting-up and maintaining of the predeter-
mined position is performed by means of a control.
Translation of the original instructions
OPTIMUM
M A S C H I N E N - G E R M A N Y
F80 | F105
®
GB
Page 395