Optimum OPTImill F 80 Betriebsanleitung Seite 269

6.5.3 Using the electronic handwheel
The electronic handwheel can always be used when
the CNC- machine is referenced,

the LED on the button <HANDWHEEL> lights up.

Press the button <HANDWHEEL> on the machine control panel to use the electronic hand-
wheel.
4
5
1
WARNING!
A manual movement of axes with open door is not possible. The F80 | F105 has no
acknowledgement button to allow movement of axes with open slide door.
The lock switch on the slide door may only be unlocked for maintenance and repair
work.
Operation
Version 1.1.2 dated 2019-05-07
Pos.
Designation
No
Rotary switch
1
Rotary switch
2
Hand wheel
3
2
<Emergency stop
button>
4
3
5
Push button resp.
acknowledge-
ment button
Translation of the original instructions
OPTIMUM
M A S C H I N E N - G E R M A N Y
Description
Selector switch to control the individual
axis.
Selector switch for the feed speed (3
stages).
Handwheel to travel the individual
axes.
The emergency stop push button
switches off the CNC- machine.
In the setting mode it is necessary to
actuate the acknowledgement button
in order to expressively allow the
movement of the individual axes.
®
F80 | F105 GB
Page 269