Optimum OPTImill F 80 Betriebsanleitung Seite 360

Brief instruction 808D Milling
Step 2
Press "Face cutt." SK on PPU.
Press the "OK" SK on the PPU
Make sure that the override value on the MCP is 0%!
Press the "Cycle Start" key on the MCP.
Adjust the override on the MCP gradually to the required values.
808D
Additional Information Part 1
Enter appropriate
data in the "Face
Milling" window
according to the
machining
requirement.
Use the button on
the right side of the
PPU to select the
cutting path of the
tool during
machining.
The system now
automatically
creates the
programs.
Page 360
OPTIMUM
M A S C H I N E N - G E R M A N Y
Operating and Programming — Milling