Optimum OPTImill F 80 Betriebsanleitung Seite 362

Brief instruction 808D Milling
SEQUENCE
You can change the time on the control if required when the clocks
Time
changes from summer time to winter time.
change
Press "Shift" and "Alarm" on the PPU simultaneously.
Make sure the password is set to the "CUSTOMER" access level.
Press the "HMI" SK on the PPU.
Press the "Date time" SK on the PPU.
Enter a new "Date" and "Time".
Press the "OK" SK on the PPU.
808D
Additional Information Part 1
+
Press "Shift" and "Alarm" on the PPU simultaneously.
Make sure the password is set to the "CUSTOMER" access level.
Page 362
Press the "Cancel" SK on the PPU to abort the
"Save data" enables the complete system to be backed up on the
Save
system CF card so that there is a system backup available to the
data
operator.
Press the "Save data" SK on the PPU.
Press the "OK" SK on the PPU.
While the control is saving data to the
system, do not operate or switch off the
control!
Operating and Programming — Milling
OPTIMUM
M A S C H I N E N - G E R M A N Y
operation.
+