Inspection And Maintenance - Optimum OPTImill F 80 Betriebsanleitung

OPTIMUM
M A S C H I N E N - G E R M A N Y
Validation
Check and maintain all safety-relevant stop, control and measuring devices (validation).
Documentation
Record all tests and works in a operator's log resp. log book.
11.2.1 Preparation
WARNING!
Only carry out work on the CNC machine, if the main switch is switched off and secured
against restarting by means of a padlock.

"Disconnecting and securing the CNC-machine" on page 219
Attach a warning sign.
11.2.2 Restarting
Before restarting run a safety check.

"Safety check" on page 217
WARNING!
Before starting the CNC machine, you must check that there is no danger for persons
and that the CNC machine is not damaged.
11.3

Inspection and maintenance

The type and level of wear depends to a large extent on the individual usage and operating
conditions. For this reason, all the intervals are only valid for the authorised conditions.
Interval Where?
GB F80 | F105
Page 292
®
What? How?

"Safety check" on page 217
Clean the sight windows made of polycar-
bonate using a suitable cleaning agent.
Cleaning

Draining
page 296
Translation of the original instructions
"Drain compressed air service unit" on
Check

Maintenance
Version 1.1.2 dated 2019-05-07