Optimum OPTImill F 80 Betriebsanleitung Seite 373

Brief instruction 808D Milling
Sample Program
Description
This unit shows three typical program examples of frequently used milling cycles and the
corresponding machining diagrams with detailed explanations.
Content
Milling
program 1
Milling
program 2
Machine
Milling
coordinate
program 3
system
End
808D
Sample Program
Drawing
Milling
program 1
Tool information:
T1 Milling tool D50
T2 Milling tool D8
Page 373
OPTIMUM
M A S C H I N E N - G E R M A N Y
Make sure all the preparations and safety measures
have been performed before machining!
The zero point of the
workpiece is located at
the center point of the
workpiece
Operating and Programming — Milling