Optimum OPTImill F 80 Betriebsanleitung Seite 364

Brief instruction 808D Milling
Additional Information Part 2
Description
This unit describes how to create a part program, edit the part program and get to know
the most important CNC commands required to produce a workpiece.
Content
MDA
M/H
function
Subprogram
Polar
coordinates
808D
Additional Information Part 2
Additive
Program
Machine
workpiece
jump
coordinate
offsets
Coordinate User Program
rotation skip
interface
ROT AROT
Machine Machine
coordinate coordinate
Scaling
Calculator
system system
User End
Program
interface
example
SEQUENCE
In MDA mode, you can enter and execute single and multiple
lines of NC codes.
MDA
Use MDA to move the axis to a fixed position.
Press the "Machine" key on the PPU.
Press the "MDA" key on the PPU.
Enter correct NC code to move the axis to the required position.
Make sure the feedrate override on the MCP is at 0%!
Press "CYCLE START" on the MCP to execute the
Turn the feedrate override on the MCP gradually to the required value.
Page 364
OPTIMUM
M A S C H I N E N - G E R M A N Y
MDA program.
Operating and Programming — Milling