Optimum OPTImill F 80 Betriebsanleitung Seite 349

Brief instruction 808D Milling
SEQUENCE
"Cycle time" shows how long the program
has been running.
"Time left" shows how much time
remains before the program ends.
Step 2
The "Time left" can only be counted after a
successful cycle run of a part program!
Select "Yes" or "No" to decide whether to
activate the counter (press the "Select"
key to activate the choice).
Enter the number of workpieces you
require to be machined in "Required".
"Actual" shows the number of workpieces
that have been machined.
808D
Machine Pieces
Piece-
Machining
Make sure that only "AUTO" mode and "ROV"
mode are activated
(or select the M01 function if required).
Notes:M01 function
there is M01 code.
Make sure that the feedrate override on the MCP is 0%!
Press "Door" on the MCP to close the door of the machine. (If
you don't use this function, just close the door on the machine
Press "CYCLE START" on the MCP to execute the program.
Page 349
OPTIMUM
M A S C H I N E N - G E R M A N Y
Make sure the program is correct before machining
pieces!
program will stop at the position where
→
manually.)
Operating and Programming — Milling
Set the program in the
ready-to-start status as
shown on the left in
accordance with the
"Program execution"
sequences.
Perform the relevant
safety precautions!