Safety; Intended Use; Warning Notice; Safety Notices - Chloride 70-NET Bedienungsanleitung

CHLORIDE 70-NET 10 - 40KVA

1. SAFETY

1.1. INTENDED USE

This device serves as an uninterruptible power supply (UPS) for connected loads. The de-
vice is in compliance with all relevant safety regulations concerning information technology
equipment, including electronic appliances for use in an office environment.
In certain configurations, battery packs are installed in the UPS devices. These may only
be connected electrically to the corresponding UPS device.

1.2. WARNING NOTICE

Danger
CHLORIDE considers the safety of personnel to be of paramount importance. For this reason it
is essential that procedures relating to safety be studied before commencing work and properly
adhered to thereafter.
• The user or Operator may only intervene in the operation of the UPS provided that
the instructions laid out in chapter "Normal and safe operation" on page 27 are strictly
adhered to.
• Installation as described in chapter "Installation" on page 13 may only be carried out
by qualified technicians.
• Even when all switches are off and isolators are open, hazardous voltages are
present within the UPS; any operation that requires protection panels to be opened
and/or removed may be carried out by authorized technical personnel only.

1.3. SAFETY NOTICES

Danger
Carefully read the following safety notices! Failure to observe the indications may endanger your
life, your safety, the reliability of your device or the security of your data.
• Use only suitable packaging to transport the device (protect against jolts and shocks).
• If the equipment is moved from a cold environment to the operating location, moisture
condensation may occur. Before commissioning the device, it must be completely dry.
Therefore, an acclimatisation period of at least two hours should be allowed.
• The equipment must be installed in accordance with the environmental conditions
specified in para. "Environmental conditions" on page 10 and "Technical Data" on
page 53
• There is no button on the panel and no switch inside the UPS that isolates completely
the device (UPS) from the mains. To do this, the power cables must be disconnected.
• In case of interruption of the mains voltage, the integrated battery maintains the
power supply to the connected loads.
• Lay the cables in such a way that no one can stand on or trip over them. When con-
necting the device to the power supply, follow the instructions in "Installation" on
page 13. It must be ensured that the live input source cannot accidentally
become connected to the UPS during installation - see "Electrical preparations"
on page 13 and "Normal and safe operation" on page 27.
• Ensure that no objects (e.g. pins, necklaces, paper clips, etc.) are left inside the
device.
• In emergencies (e.g. damaged case, controls or power cables; penetration of liquids
or foreign matter) switch off the device, disconnect the power cables and contact the
appropriate customer service representative.
• Do not connect equipment that may overload the UPS (e.g. laser printers or vacuum
cleaners) or demand DC-current (e.g. half-wave rectifiers).
• The sum of the leakage currents (protective conductor current) of the UPS and the
connected devices may exceed 3.5 mA for all ratings. Earth connection is essential
before connecting supply.
User Handbook - 10H52163PAMC rev.9 - 06/2008
SAFETY
ENG
Page 3