Restarting; Inspection And Maintenance - Optimum OPTidrill DH 40CT Betriebsanleitung

6.1.2

Restarting

Before restarting, run a safety check.

Safety check on page 62
WARNING!
Before starting the drilling milling machine you must be sure that

lead to any danger with respect to people,

the drilling milling machine is not damaged.
6.2

Inspection and maintenance

The type and level of wear depends to a large extent on the individual usage and operating
conditions. Any indicated intervals therefore are only valid for the corresponding approved con-
ditions.
Interval Where?
Start of shift
after every
maintenance or
repair work
Start of shift
after every
maintenance or
repair work
Maintenance
Version 1.0.1 - 2021-07-06
What? How?

Safety check on page 62

Check if the oil level can be seen in the oil sight glass. The
sight glass should be half-covered.
Img.6-1: Oil sight glass
Translation of original instruction
Oil level
Oil sight glass
DH 40CT EN
87