Maintenance; Safety; Preparation; Restarting - Optimum OPTImill MH 25 SV Betriebsanleitung

6

Maintenance

In this chapter you will find important information about
Inspection

Maintenance

Repair

of the milling machine.
ATTENTION!
Properly performed regular maintenance is an essential prerequisite for

operational safety,

failure-free operation,

long service life of the milling machine and

the quality of the products which you manufacture.
Installations and equipment from other manufacturers must also be in good order and condition.
6.1

Safety

WARNING!
The consequences of incorrect maintenance and repair work may include:

Very serious injury to personnel working on the milling machine,

Damage to the milling machine.
Only qualified technical personnel should carry out maintenance and repair work on the
milling machine.

6.1.1 Preparation

WARNING!
Only carry out work on the milling machine if it has been disconnected from the mains
power supply.

"Switching-off and securing the milling machine" on page 63
Attach a warning sign.

6.1.2 Restarting

Before restarting, run a safety check.

"Safety check" on page 62
WARNING!
Before starting the milling machine, you must check that there is no danger for persons
and that the milling machine is not damaged.
6.2

Inspection and maintenance

The type and level of wear depends to a large extent on the individual usage and operating
conditions. Any indicated intervals therefore are only valid for the corresponding approved con-
ditions.
Version 1.0.1 dated 2015-12-17 Original operating instructions
OPTIMUM
M A S C H I N E N - G E R M A N Y
MH25SV GB
Page 85