Inspection And Maintenance - Optimum OPTImill BF 46TC Betriebsanleitung

5.2

Inspection and maintenance

The type and level of wear depends to a large extent on the individual usage and operating
conditions. For this reason, all the intervals are only valid for the authorised conditions.
Interval Where?
Start of work,
after every
maintenance or
repair work
Start of work,
after every
maintenance or
repair work
Every week
Every week
Version 1.1.3 dated 2014-4-8
What? How?
 
"Safety check" on page 65

Actuate the central lubrication of the cross table and of the
drill-mill head with five pump strokes. If required refill acid-
free oil in the tank of the central lubrication.
Oiling

Oil all bare steel surfaces. Use an acid-free oil, e.g.
Oiling
weapon oil or motor oil.

Check the oil level of the gear. The oil level must be in the
middle of the sight glass.
Oil level
Original operating instructions
OPTIMUM
M A S C H I N E N - G E R M A N Y
Filling hole
Img.5-1: Central lubrication
Oil sight glass
Abb.5-2: Oil sight glass gear
BF46V | BF46TC GB
Page 97