Setting The Clipx Using A Web Browser - HBM ClipX Bedienungsanleitung

You can reset both passwords by loading the factory default setting in the
Device menu (Without network settings is sufficient).
When connecting via the fieldbus interface, you can enable the Maintenance or Admin-
istrator user level directly for the browser by one command, without entering a pass-
word. When doing so, you must specify a time for which the password deactivation is to
apply, up to a maximum of 24 hours. You can also disable the selected user level pre-
maturely, or extend the time period. The active user level is also available in the browser
as from the time of switching and for the specified period of time, and is displayed
accordingly. The setting via the fieldbus has priority over any setting made in the
browser.
See „Object dictionary" on page
For the connection via the fieldbus itself you do not need a password; all functions are
always accessible there.
7.4

Setting the ClipX using a web browser

Click on
You make all the settings for sensors and signal processing in your browser. You can
view help on each topic by pressing F1 or clicking on
LED of the ClipX being used flash red/green if you have connected multiple ClipX
devices.
The start screen of the ClipX displays the current measured values (gross and net sig-
nals), peak and captured values, the status of the limit value switches and the digital
inputs and outputs, as well as the values of the calculated channels and the values
transmitted over the bus systems. If no valid values are received from one of the data
INVALID
sources,
The net signal (default) is additionally displayed in graph form. Click on the signal name
to display a different signal (the setting is not saved). It is not currently possible to
change the display rate or the scaling.
has a TEDS module and it has been successfully read.
78
159.
to switch language.
is displayed.
. Click on
TEDS
is additionally displayed if the transducer
to make the SYS
ClipX
Starting up the ClipX