Safety Instructions - HBM ClipX Bedienungsanleitung

S
1
AFETY INSTRUCTIONS
Read this operating manual before operating the device for the first time. Any persons
assigned to install, commission, operate or maintain the device must have read at least
the sections of the operating manual of relevance to them.
The operating manual forms part of the product. Keep it in a safe place so that it is per-
manently accessible to all users. If you pass the device on to a third party, always pass
it on together with the relevant documents.
Intended use
The ClipX amplifier system is to be used exclusively for measurement tasks and directly
related control tasks (automation systems). Use for any purpose other than the above is
deemed to be non-designated use. In the interests of safety, the device should only be
operated as described in the operating manual.
The device may only be powered by a safety extra low voltage (DIN EN 61558 or VDE
0570, Safety of transformers, reactors, power supply units and combinations thereof).
The supply voltage must be between 10 V and 30 V (DC).
Conditions at the place of installation
• Protect the device from direct contact with water.
• Protect the ClipX from moisture and dampness or weather such as rain, snow, etc.
• Do not expose the device to direct sunlight.
• Please observe the permissible maximum ambient temperatures stated in the
specifications.
• The permissible relative humidity at 31 °C is 95 % (non condensing); linear reduc-
tion up to 50 % at 40 °C.
• It is safe to operate the ClipX up to an altitude of 2000 meters.
Conversions and modifications
The device must not be modified from the design or safety engineering point of view
except with our express agreement. In particular, any repair or soldering work on moth-
erboards is prohibited. The device must not be opened. The product is delivered from
the factory with a fixed hardware and software configuration. Changes can only be
made within the possibilities documented in the operating manual.
ClipX

Safety instructions

5