Clip Xdevice Types Scope Of Supply; Device Types - HBM ClipX Bedienungsanleitung

C X
4
LIP

DEVICE TYPES

The ClipX is mounted directly on a support rail, though other mounting methods are
also possible. The ClipX is supplied as standard with easy-fit push-in type plug termi-
nals. You can also use screw-type plug terminals from Phoenix Contact – see
cal connections, LEDs" on page
You can connect strain gage full or half bridges, voltage-fed piezo-resistive sensors,
current or voltage sensors and currents or voltages, potentiometer transducers or
Pt100s to the transducer connector. Two freely configurable digital input/outputs and
an analog output for current or voltage are additionally available.
Important: All basic settings are made via the web server integrated into the
ClipX and your web browser. The web server includes its own help, which
explains all the ClipX settings. Depending on the design, you can also con-
nect the ClipX to various fieldbuses.
4.1 Device types
The ClipX comes in three different design versions. All the design versions feature the
same sensor inputs, two freely configurable digital input/outputs, and an analog output
switchable for current (4 ... 20 mA) or voltage (±10 V):
1. BM40
This version does not include a fieldbus.
2. BM40PB
This version includes a PROFIBUS
3. BM40IE
You can operate this version with a one of the interfaces for PROFINET
1)
Net/IP™ , EtherCAT
1)
EtherNet/IP™ is a trademark of ODVA Inc. For more information regarding ODVA, visit
www.odva.org.
2)
®
EtherCAT is a registered brand and patented technology, licensed by Beckhoff Automa-
tion GmbH, Germany.
ClipX
ClipX device types, scope of supply
,
SCOPE OF SUPPLY
19.
®
interface.
®
2)
or Modbus TCP. The interfaces are switchable via software.
„Electri-
®
, Ether-
11