Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Abb. 5:
Screws to remove the support rail mount
Procedure
1.
Use a size T10 Torx screwdriver to remove the screws indicated in the picture.
2.
Keep the screws, because you should reuse them.
3.
Make your mounting bracket.
The material should be about 1 to 2 mm thick, to enable you to reuse the original
(M3) screws. The space between the two screws is 43.7 mm.
4.
Fix your mount either using the original screws or using M3 screws penetrating a
maximum of 5 mm into the housing. Fasten the screws only hand-tight.
Important: You must ground the ClipX housing, such as by way of the
mount.
ClipX
Mounting
17
Werbung
Inhaltsverzeichnis
