HBM ClipX Bedienungsanleitung Seite 53

LOAD TEDS FILE
2. Use
device storage. See also
The file name may comprise a maximum of 37 characters, including the extension
.ted
( ).
3. Select the file from the Available TEDS files drop-down list.
WRITE FILE INTO TEDS MODULE
4. Click on
5. Confirm the writing process with
from the file to the sensor's TEDS module.
Any existing data in the TEDS module will be lost when you do so. Click on a free
input range to cancel the action.
The TEDS data is checked before being written. If an error occurs, the file is not written
to the TEDS module, though it is already in the device storage. So the measured value is
INVALID
identified as
essary, for example by removing the sensor and re-attaching it or by clicking on
AGAIN
in the Settings area.
ClipX
Electrical connections, LEDs
to load the file containing the TEDS data into the ClipX's
„Device storage (Device cloning)" on page
. Read out the TEDS module containing the old data again as nec-
.
CONFIRM OVERWRITING
100.
to write the data
TRY
51