HBM ClipX Bedienungsanleitung Seite 212

Standstill detection (block type 19), available with firmware 2.6 or higher
Index Subindex
0x510n 20
21
22
23
24
30
31
32
210
Function
Input.
Time period.
Amplitude.
Threshold High.
Threshold Low.
Standstill flag.
Near-zero flag.
Output.
Value
0 ... 47, see „List of signal refer-
ences" on page 218, UINT16.
0 ... 60.000, time period in ms
within which the signal fluc-
tuations must be smaller
than the amplitude, UINT16.
> 0.0, FLOAT.
≥ 0.0, maximum permissible
positive value at which the
near-zero condition is still met,
FLOAT.
≤ 0.0, maximum permissible
negative value at which the
near-zero condition is still met,
FLOAT. The value must be
entered with a minus sign.
Flag number 12 ... 19, 64, see
„Digital flags: List of I/O flags
(I/O status)" on page
UINT8.
Flag number 12 ... 19, 64, see
„Digital flags: List of I/O flags
(I/O status)" on page
UINT8.
21 ... 26, 48, see „List of signal
references" on page
UINT16.
Operation via fieldbus
157,
157,
218,
ClipX