HBM ClipX Bedienungsanleitung Seite 154

9.6 Flags and status bits
The following sections set out the assignments of the individual bits to the various
functions for the three status fields for measured value status, system status and flags,
and the bits of the control word.
9.6.1 Measured value status: List of status bits
The following table sets out the bits set in the measurement status (32 bits) if the signal
in question is invalid.
You can change some of the (default) signal names, e.g. ClipX bus value 1
to Pressing force. This means your names might differ from the ones in the
table.
Designation
Electrical value (field
value)
Gross
Net
Minimum
Maximum
Peak-to-peak
Captured value 1
Captured value 2
ClipX bus value 1
ClipX bus value 2
ClipX bus value 3
ClipX bus value 4
ClipX bus value 5
ClipX bus value 6
152
Bit Explanatory note for bit set i.e. value is invalid
Input signal in the unit of the measured quantity,
2
e.g. in mV/V.
3 Gross signal.
4 Net signal.
5 Peak value minimum.
6 Peak value maximum.
7 Peak value peak-to-peak.
8 Captured value 1.
9 Captured value 2.
10 Value on ClipX bus from the device with address 1.
11 Value on ClipX bus from the device with address 2.
12 Value on ClipX bus from the device with address 3.
13 Value on ClipX bus from the device with address 4.
14 Value on ClipX bus from the device with address 5.
15 Value on ClipX bus from the device with address 6.
ClipX
Operation via fieldbus