Updating The Firmware - HBM ClipX Bedienungsanleitung

U
11
PDATING THE FIRMWARE
You update the firmware in your web browser by choosing Device from the menu – see
also „Setting the ClipX using a web browser"on page
Procedure for firmware update
1. Download the current firmware from the HBM website:
https://www.hbm.com/ClipX.
2. Connect your browser to the ClipX.
3. Click on Device in the menu.
CHOOSE FIRMWARE
4. Click on
UPDATE FIRMWARE
5. Click on
Do not disconnect your PC from the ClipX while downloading the file! If anything goes
wrong when updating the firmware, such as if the power fails, either the ClipX restarts
with the old firmware, or the device loads and initializes the new/loaded firmware. The
ClipX is ready to run again after about five minutes. If the update fails, repeat it. After
successfully updating, wait until the device is ready again before reconnecting. The SYS
LED on the device lights up green to indicate when the device is ready again and that all
settings are valid. If settings are invalid the LED flashes yellow or red.
All settings are retained on a firmware update. However, we recommend you
back up the device settings beforehand. (Device Storage menu item – see
also „Device storage (Device cloning)"on page
Sys LED state during a firmware update
SYS
Status
LED
On or flash-
ing
Red
/
Flashing
Yel-
low/red
On
Yellow
ClipX

Updating the firmware

and specify the file you have downloaded.
.
Meaning
The ClipX is booting up (initializing everything).
The ClipX checks the file integrity, copies or expands files.
The ClipX clears the CPU flash memory.
78.
100).
223