HBM ClipX Bedienungsanleitung Seite 89

Start by a limit value
Signal at
Input
0
1
0
2
Abb. 48: Checkweigher, Start via threshold
The specified limit value is used in the example for both start conditions. Use a User-
defined Constant (Calculated Channels menu at bottom) for the limit value. Also set the
Start Measure with and Start Zeroing with conditions to 0 (internal constant).
ClipX
Starting up the ClipX
3 4
Meas. Meas.
Delay Time
Update of Maximum Value,
Minimum Value, Peak-to-Peak
and Mean
5 6
Zero Tracking
Delay
Threshold
Measured Value
7 2
Zero
Tracking
Time
Update Offset
t
Ready Flag
Status
87