HBM ClipX Bedienungsanleitung Seite 125

Name
Fieldbus UINT
flags
Control word UDINT
Parameter UINT
set number
Object dic- UINT
tionary read (Index)
request USINT
(Sub-
index)
USINT
(Pad-
ding)
ClipX
Operation via fieldbus
Cycle in
Format
ms
1
1
1
1
Function
16 control flags that can be used universally
in the ClipX like internal flags, such as to
reset peak values.
These flags are transferred in the digital flags
into bits 32 ... 47.
See also „Digital flags: List of I/O flags (I/O
status)" on page 157,
ClipX to the controller" on page
32 control flags with fixed assigned func-
tions.
See „The control word" on page
Parameter set number 1 ... 10.
Switches the ClipX to the parameter set with
this number. The ClipX only reacts to a
change in this value.
If you want to reactivate the original (same)
parameter set after changing settings, you
must first change the value. You can also
specify a non-existent parameter set number
when doing so.
Read an object in the object dictionary by
index and subindex. The padding byte has no
function – see „Object dictionary" on page
159.
The ClipX only reacts to changes in Index,
Subindex, Padding Byte or Value. It does not
react if Index = 0x0000 (no operation). To
repeat reading or writing, change the request
in at least one variable. For example, set the
index first to zero and then back to the
desired value.
You can only read data objects up to 32 bits
in size.
See also „Data transfer from the ClipX to the
controller" on page
the ClipX objects?" on page
„Data transfer from the
125.
158.
125, „How do you access
161.
123