Measured Value Status: List Of Status Bits - HBM ClipX Bedienungsanleitung

Check the status either via the LEDs
web browser by the indicator next to Status at the top right in the window:
Modbus: NO CONFIG
Modbus: IDLE
Modbus: RUN
Register for transferring from ClipX to Modbus (input)
See also
Discrete Input reg-
input ister
0 ... 31 0 ... 1
32 ... 95 2 ... 5
96 ... 127 6 ... 7
128 ... 159 8 ... 9
10 ... 11
12 ... 13
14 ... 15
16 ... 17
148
„Data transfer from the ClipX to the controller" on page
Meaning
Return value of the control word.
See „The control word" on page
Coil 0 contains bit 0 'Zero'.
IO flags.
See „Digital flags: List of I/O flags (I/O status)"
on page
Coil 32 contains flag 0 'Digital input 1'.
System status bits.
See „System status: List of status bits" on
page 153.
Coil 97 contains system bit 0 'Device ready'.
Tip for testing: Poll discrete input #127 (heart-
beat flag).
Measured value status bits.
See „Measured value status: List of status
bits" on page
Coil 130 contains status bit 2 'Electrical value
(Field value)'.
Filtered ADC value
Electrical value (field value)
Gross
Net
(„Health-Monitoring, LEDs" on page
The ClipX is waiting for an IP address.
The ClipX is waiting for a connection.
The gateway ClipX is connected.
157.
152.
26) or in the
125.
Format
Bit array
158.
Bit array
Bit array
Bit array
REAL
REAL
REAL
REAL
Operation via fieldbus
ClipX