Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
No.
Description
5
X5: Fieldbus, here PROFIBUS (only BM40PB)
6
HBM calibration label and free labeling space
Reset button, see
7
work settings (DHCP), enabling fixed IP address" on page 75
Fieldbus LED 1, only BM40IE; EtherCAT, Modbus-TCP: ERR, PROFINET: BF,
8
EtherNet/IP™: NS
Fieldbus LED 2, only BM40IE and BM40PB; EtherCAT, Modbus-TCP: RUN,
9
PROFINET: SF, EtherNet/IP™: MS; PROFIBUS: BUS
10
System LED
X6, X7: 2 x RJ45; P1/IN (X7) and P2/OUT (X6) for EtherNet/IP™, PROFINET,
11
EtherCAT or Modbus-TCP (only BM40IE)
See also
„Electrical connections, LEDs" on page 19
screw connections and relating to coding pins.
Electrical isolation of the GND connections
The following connections are electrically isolated from each other:
•
DI, GND (Ground) Digital-In: Reference potential for DI1 and DI2.
•
X, GND ClipX bus: Reference potential for ClipX bus (CxA, CxB) and Sync; on the
BM40PB PROFIBUS-GND is also connected by this.
•
AI, GND Analog-In: Reference potential for U-In and I-In; the adjacent measurement
inputs for voltage and current.
•
S GND for the inner shield on double-shielded cable; with 1-Wire TEDS, TEDS (–) is
also connected here.
•
AO, GND Analog-Out: Reference potential for the analog output.
ClipX
Electrical connections, LEDs
„User Management" on page
77,
„Resetting Ethernet net-
for plug terminals with
25
Werbung
Inhaltsverzeichnis
