HBM ClipX Bedienungsanleitung Seite 119

is received from the HTTP server five times in a row, or if the response indicates an error
(values less than 200 or greater than 299).
Further display or analysis is not possible from the ClipX, so in the event of problems
you usually have to search for the error at network level.
Example
Device ID: clipx
Endpoint URL: http://192.168.178.29:8800/test
Send interval: 1000 ms
Sampling interval: 200 ms
Packet sent
POST /test HTTP/1.1
Host:192.168.178.29:8800
Content-Type: application/json; charset=utf-8
content-length: 290
{
"content-spec":"urn:spec://eclipse.org/unide/measurement-message#v2",
"device":{
"deviceID":"clipx-29-ac"},
"measurements":[{
"ts":"2020-04-28T11:31:53.042Z",
"series":{
"$_time":[0,200,400,600,800],
"Gross":[-0.0048,-0.0051,-0.0051,-0.0053,-0.0048], precision 2
"Calculated Value 1":[-27,173,373,573,773]}
}]
}
Explanation
The names of the measurement or calculation channels are the names you set on the
device.
The time stamp ts is the sampling time of the first measured value of each channel. The
time offset of the following measured values is in the series $_time. The time source is
the system time of the ClipX. For exact times, enter an NTP server in the Network menu.
ClipX
117
Operation via Ethernet/OPC UA/PPMP