HBM ClipX Bedienungsanleitung Seite 108

You must interpret the return value bit-wise. Starting from bit 0, bit 3 is the status for
the gross measurement value (value in the
In this example, the gross measurement value is valid, as are the peak values and cap-
tured values. The values on the ClipX bus are invalid (0: valid; 1: invalid).
Example 3: Zero balancing (zeroing)
Function
Command
Response
1)
You can also use CRLF in place of LF
The command was executed without error.
You must specify the last parameter (value 0) in order to maintain the SDO
syntax. The parameter is ignored by the ClipX.
Example 4: Setting sensor type ±10 V
Function
Command
Response
1)
You can also use CRLF in place of LF
The command was executed without error.
Example 5: Setting the filter cut-off frequency to 0.5 Hz
Function
Command
Response
1)
You can also use CRLF in place of LF
The command was executed without error.
106
Command/response
SDO 0x4410,4,0LF
0CRLF
Command/response
SDO 0x4400,1,0LF
0CRLF
Command/response
SDO 0x4401,2,0.5LF
0CRLF
„List of signal references" on page 218
1)
1)
1)
Operation via Ethernet/OPC UA/PPMP
+1).
ClipX